Exact product identification
Your quotation references the complete manufacturer part number to keep the requested product clear.

C4C-EA09010A10000
Single deTec4 Core receiver for a 900 mm nominal protective field and 14 mm detection capability. Pairs with C4C-SA09010A10000. 24 V DC, M12 5-pin system connection; matching counterpart ordered separately.
Warranty coverage and terms are confirmed with your order.
We coordinate the fastest available shipping option for your destination.
Available payment methods are handled through secure payment channels.
Carrier and delivery options are confirmed for your destination before dispatch.
Independent supplier: Xindustra is not an authorized distributor, reseller, or representative of SICK. Brand names are used for identification and compatibility purposes only. Read disclaimer
Component role, detection performance and installation details for C4C-EA09010A10000.
C4C-EA09010A10000
1211515
Receiver only
C4C-SA09010A10000
14 mm
900 mm
913 mm
14 ms
0–8 m
0–10 m
Optical
This order code supplies the receiver bar. A complete protective field requires the corresponding sender C4C-SA09010A10000, matching height and resolution, suitable mounting and connections, and integration into the machine’s safety control.
The receiver monitors the light field and provides two monitored PNP semiconductor OSSDs. The outputs switch off when the protective field is interrupted or a relevant fault is detected. Connect both OSSD channels to the downstream safety circuit.
The nominal protective height describes the monitored vertical span; 14 mm is the detection capability, and scanning width is the sender-to-receiver separation. Use the signal-reserve range when laying out the station; typical optical reach is not an unconditional installation distance.
19.2–28.8 V DC; 24 V DC nominal, SELV/PELV
2.88 W excluding power delivered through OSSD loads
M12 male, 5-pin, on 150 mm cable
+24 V DC
0 V DC
OSSD1
OSSD2
Not assigned
300 mA each
At least one OSSD in OFF state
Operating instructions p.46. Sender reserved pins and receiver OSSD pins have different functions.
The manufacturer requires a supply that buffers brief 20 ms interruptions and a maximum 4 A fuse in the 24 V device supply circuit. The receiving safety inputs must tolerate the receiver’s OSSD test pulses; the receiver power figure excludes the current supplied to external OSSD loads.
The deTec4 Core system is Type 4, Category 4, PL e and SIL 3 under the manufacturer’s stated conditions. Place it at the calculated separation from the hazard using the complete stopping time, including the device response, downstream control and machine stop. Implement restart interlock and external device monitoring in the downstream safety control where required by the application.
31 × 34 mm, plus bracket
913 mm
850 g, ±50 g
Aluminum extruded profile
Scratch-resistant polycarbonate
IP65 / IP67
−30 to +55 °C
15–95%, noncondensing
Operating instructions p.64. Select the row for the nominal protective height; brackets add to the installed envelope.
Mount sender and receiver opposite each other with clear optical alignment. Arrange guarding to prevent reaching over, under or around the field, and keep reflective surfaces outside the specified minimum distance. Perform the prescribed test-rod and restart checks after installation or changes.
The selected references are deTec4 Core for normal industrial environments. deTec4 Prime, Core HG, explosion-protected versions and 30 mm models have separate identifiers and capabilities. Matching external appearance does not establish that components from different versions form a supported pair.
Order the exact product and condition your project requires, with assistance from quotation through delivery.
Your quotation references the complete manufacturer part number to keep the requested product clear.
Tell us whether you need new original, new surplus, used, refurbished or repaired equipment.
Shipping options are prepared around your destination, quantity and requested delivery date.
Access available manufacturer product data, manuals and certificates associated with the order number.