Omron S8VK-G06024 24 V DC DIN Rail Power Supply

Set the output for the connected24 V loads and measure the actual voltage after adjustment. Increasing voltage does not increase the permitted output power or current. Do not supply this unit from an inverter output.

Overload protection automatically clears when current returns within the rated range. Overvoltage protection shuts off the output at approximately130% or more of nominal voltage; remove the cause, switch input power off for at least three minutes, then reapply power.

The 3 A boost value supports temporary demand above the 2.5 A rated current. Each boost interval must be10 seconds or less, boost duty30% or less, and average current over the full cycle no higher than the rated current. Ambient temperature and mounting orientation also limit the available load.

The specified ambient range is−40 to+70 °C with temperature-dependent derating, no condensation or icing. At−40 to−25 °C, startup takes longer and ripple can exceed the normal table value. Full rated load is not available at every temperature or orientation.

Up to two units of the same model can operate in parallel at−25 to+40 °C. Adjust output voltage difference to50 mV or less, use matched lead length and thickness, and establish balanced output currents. There is no automatic current-balancing function; rapidly changing loads may require the specified redundancy unit or diode arrangement. Series operation also requires the manufacturer’s external diode circuit.

Keep at least30 mm clearance above and below for convection and20 mm around the indicated neighboring surfaces. Connect PE and route input and output to their marked terminals. Standard vertical mounting provides the primary rating; horizontal mounting needs the appropriate bracket and derating. Side mounting is supported only for15 W models with the specified bracket.